Hundred Nitrix 80 Bullet Badminton Racket

The Hundred Nitrix 80 Bullet is a head-heavy attacking badminton racket built on a 5.9mm shaft, the thinnest shaft Hundred has put into the Nitrix line. It uses Curve² frame geometry, holds tension up to 32 lbs, and comes in a G6 grip. Available in two weights that are not just weight variants: the 3U runs a hard-flex shaft, the 4U runs mid flex.

Key specifications

• 5.9mm shaft: thinner than the Nitrix 70 Venom (6.1mm) and the Nitrix Pro (6.5mm). Less air drag through the swing, faster head speed for the same effort.
• Head-heavy balance: loads momentum into the smash and rear-court clears.
• Curve² frame geometry: curved isometric head that widens the effective sweet spot for off-centre contact.
• 32 lbs maximum tension: enough ceiling for tournament-level stringing.
• G6 grip: the smaller of the two common Indian sizes.
• Weight options: 3U (85 to 89g) hard flex, 4U (80 to 84g) mid flex.

3U vs 4U: which Nitrix 80 Bullet to buy

The two versions differ by more than four grams. Each weight has a different shaft flex, so they play differently.

Short answer: take the 3U if your smash is your main weapon and you swing hard and early. Take the 4U if you play flat, rotate quickly, and want the shaft to help generate pace. If you are unsure, the 4U is the safer buy for most Indian club and league players.

What the 5.9mm shaft actually does

A thinner shaft cuts drag, so the racket head arrives faster for the same arm speed. That is useful when you are reaching late for a lift or trying to hit a flat drive past someone at the net.

The trade-off is margin. A 5.9mm shaft transmits more of what happens at contact straight into your arm, so clean centre hits feel excellent and mistimed ones feel dead and jarring. This is not a frame that hides a poor swing.

Who this racket is for

• Advanced and tournament players who finish rallies from the rear court
• Doubles players who rotate front to back and need speed in flat exchanges
• Players moving up from the Nitrix Thunder or Nitrix Attack who want a genuinely pro-level shaft
• Anyone who already strings at 26 lbs or higher and hits clean centre contact

Who should skip it

• Beginners and early intermediates. The shaft is too unforgiving and the head-heavy balance tires the shoulder. Look at the Nitrix Thunder instead.
• Defensive and control-first players. The Hyfonic series is built for that game.
• Anyone with wrist or elbow trouble. Thin shaft plus head-heavy balance sends more shock up the arm than an even-balance frame.
• Players wanting to string above 32 lbs. Going past the stated ceiling voids the warranty.

Where the Nitrix 80 Bullet sits in the Hundred range

• Atomic X: entry-level attacking frames
• Nitrix Thunder: intermediate, 7.0mm flexible shaft
• Nitrix Attack (Kidambi Edition): intermediate, 6.5mm slim shaft
• Nitrix Pro: pro-level, M46X carbon, 6.5mm hard flex
• Nitrix 70 Venom and Nitrix 70 Volta: Pro Series flagships, 6.1mm and 7.1mm
• Nitrix 80 Bullet: thinnest shaft in the line at 5.9mm, offered in two flex profiles

Stringing recommendations

The racket ships unstrung. We offer professional stringing before dispatch as a paid service, so you can choose your string and tension at the time of order rather than finding a stringer locally.

• 24 to 26 lbs: if this is your first head-heavy pro frame. Bigger effective sweet spot while you adjust.
• 26 to 28 lbs: the range most advanced club and league players will want.
• 28 to 32 lbs: only if your centre contact is consistent. Above 28 lbs the 5.9mm shaft leaves very little margin on off-centre hits.

For string choice, a 0.68mm gauge lasts longer, while 0.61mm to 0.63mm gives noticeably more repulsion at the cost of string life. Browse badminton strings to pick one.

Frequently asked questions

Is the Hundred Nitrix 80 Bullet good for beginners?

No. It is a head-heavy professional-level frame on a 5.9mm shaft. Off-centre hits feel dead and the balance loads the shoulder over long sessions. Beginners should start with an even-balance 4U or 5U racket with a thicker, more flexible shaft.

What is the difference between the Nitrix 80 Bullet 3U and 4U?

Weight and shaft flex. The 3U is 85 to 89g with a hard-flex shaft; the 4U is 80 to 84g with a mid-flex shaft. Both share the same 5.9mm shaft thickness, Curve² frame and 32 lbs tension ceiling. The 4U swings faster and gives more shaft-assisted repulsion, the 3U is more stable and direct through contact.

What is the maximum string tension for the Nitrix 80 Bullet?

32 lbs. Stringing above the stated maximum risks frame deformation and voids the manufacturer warranty.

Is the Nitrix 80 Bullet head-heavy?

Yes. The weight sits towards the head, which is what puts force behind the smash. That same balance is why it is not recommended for defensive or control-focused players.

What grip size does it come in?

G6, the smaller of the two sizes commonly sold in India. If you normally play G5 or G4, plan on one or two overgrips to build the handle up.

Does it come strung?

No, it ships unstrung. Professional stringing at your chosen tension is available as a paid add-on before dispatch.

How does the Nitrix 80 Bullet compare to the Nitrix Pro?

The Nitrix Pro uses a 6.5mm hard-flex shaft with M46X Japanese carbon and is Srikanth Kidambi's frame. The Nitrix 80 Bullet goes thinner at 5.9mm and offers a mid-flex option in 4U, which the Nitrix Pro does not. Pick the Pro for a stiffer, more established platform; pick the Bullet for faster head speed and, in 4U, more shaft assistance.

Is this a genuine Hundred racket?

Yes. SportsUncle has been retailing genuine badminton equipment since 2016, and every Hundred racket we ship carries full manufacturer warranty. Browse the full Hundred range or all badminton rackets.